===Honeycomb Parameters===
In the summer of 2019, two new honeycombs were installed on the shelf of the wind flume.

The honeycomb was ordered from //PLASCORE// with the following parameters:\\
ALSLICE ALUMINUM HONEYCOMB\\ 
PCGA-XR2-1.2-1/0-30-P-3003\\ 
70 X 1524 X 2000 [mm^3]\\
  * Perforated core
  * Expanded Sheets
  * XR2 corrosion coating is a chrome-free clear protective film
    * cost was 837.34 USD for **two** sheets, including shipment, **NOT** including tax.

The honeycombs were glued on to aluminum frames (80 [mm] depth) and placed in two locations:\\

  * Upper honeycomb:
    * roughly 31 [cm] height
    * roughly 100 [cm] from wind inlet 
    * tilted forward roughly 8 [deg] 
    * held into place by two bolts and two 90 degree angles that were drilled into the shelf

  * Lower honeycomb:
    * roughly 58 [cm] height
    * roughly 175 [cm] from wind inlet 
    * has two main vertical positions:
      * straight (i.e. STR)- positioned vertically relative to water surface
      * angled (i.e. ANG)- positioned forward to roughly 8 [deg] 
    * held into place by two bolts and two 90 degree angles that were drilled into the shelf

===Measurements===
On July 16-17 2019, measurements of instantaneous water surface fluctuations were performed with the following parameter changes:\\
  * blower frequencies (20, 30 & 40 [Hz])
  * fetches (450 & 1100 [cm]) from the **upper** honeycomb
  * vertical position of the **Lower** honeycomb (STR & ANG)
All measurements were performed by 3 consecutive wave gauges (WG) with a sample frequency of 80 [Hz] and measurement time of 6,000 [sec]. The surge distances between the WG were:\\
  * 2.1 [cm] between WG1 & WG2
  * 11.8 [cm] between WG2 & WG3

===Analysis===