blowermotor
Table of Contents
Wind Blower Motor (3.5kW, 10HP, 3ph)
The ratings are in the image below
BLOWER PROCEDURE
Turn On Blower and Generate Wind:
a) Flip up the switch labeled BLOWER in the fuse box located beneath the stage
b) Open LabVIEW Program called
\\BasicDataShare\Software\VI Files\ctrlSpeedBlower.vi
located in D:\Experiment\VIs\Blower
c) Type the desired wind frequency in [Hz] and run the program
If the blower doesn't start:
Switch off and on again the switch on the left of the PC desk (as shown in picture).
Turn Off Wind:
To turn off the wind enter the frequency “0” [Hz] in CtrlSpeedBlower Program (the blower will eventually go into “Standby mode”).
Turn Off Blower:
Flip down the switch labeled BLOWER in the fuse box located beneath the stage.
blowermotor.txt · Last modified: by tsail